So you have reset your Linksys WiFi extender and restored the factory settings on it. Now you have no idea what is to be done. Since you are reading this post we assume this statement to be true. After Linksys WiFi extender reset, you need to set it up from the very beginning and give it a fresh start. Yes! After reset process, the extender is as good as a new device. The settings that you customized on it have been erased. So, you need to perform its setup once again. Read this post completely to know how to set up your Linksys extender.
How to Set Up Linksys Extender After Reset?
Setting up the Linksys extender means connecting it to the home network or the main router. The extender works by taking in the signals from the router and extending it further. So, you need to connect these two devices. The steps highlighted below will help you make the connection and complete the setup.
Place the Devices Closer
Begin the process by placing the Linksys WiFi extender next to the host router in the same room. There ought to be an available wall outlet here so that you can plug in the Linksys extender. Placing the devices closer during the Linksys extender setup process is essential. Once the connection is made you can move the extender away from the router. But then also the extender must sit within the range of the host router.
Make a LAN Connection
Now, use a LAN cable that is in good condition and use it to make the connection between the extender and router. The cable must make a solid and secure connection. Verify the connection that you’ve made before you proceed further.
Let us tell you that you can also opt for a wireless connection between the two devices. However, during the setup process, make a LAN connection and later on you can get them connected wirelessly.
Power On the Devices
It is now time you power on the device that you want to connect. Make sure that you are following the same sequence that we are providing here. Firstly, turn on the main router. Then you need to power on the Linksys WiFi extender. Both these devices must be fully booted up and receiving a consistent power connection.
Join the Linksys Extender Network
Now, turn on your PC that you want to use to complete the setup of the WiFi extender. Connect it to the extender default SSID Linksys extender setup-xxx. This is an essential step as you can access the setup page only when you are connected to the correct network i.e. the extender’s network.
- Also read – Lulubox Pro Apk
Access Web Interface
The time has come for you to open the setup page of your Linksys wireless extender. Use the extender’s login address extender.linksys.com and go to the setup page. You can also use the default IP if the URL does not help you. Follow the instructions that you see on the screen and complete the Linksys extender setup.
The Final Note
Now that you have set up your Linksys extender, you can shift it to a new place where you want the extended signals. You should also check for firmware updates for your extender. Different Linksys extender models have different updates released. If you have a Linksys extender setup RE7000 done, then check for the firmware updates for this specific extender model. Get the extender updated if you find an update ready. This will enhance the overall performance of your Linksys device.
This is all about how you can set up your Linksys extender after you have reset it to the factory settings. With the hope that this information suffices to meet your needs, we put a full stop to our article.
